Gamerlolwind
Well-Known Member
hay guys,
I'm getting very encouraged by my ds lite mod i recently did and im also working on a new way to finish my GCP.
um, i was looking at ashen's diagrams for the gc memroy card + micro sd adpter:
and im thinking of making a gc memcard <=> Micro SD adapter mod as my sd card i use for homebrew/swiss related is a micro sd 32gb card.
anyways, about soldering the pins of both cards together using ashen's diagrams,
i solder the pins like so:
SD adapter = GC mem
1 = 9
2 = 5
3 = 2
4 = 4 or 8?
5 = 11
6 = 10
7 = 7
8 = nothing
9 = 3
for the gc men card pins 12, 1, 6 i don't need to worry about as im not soldering it to the gc men port, right?
also, i can use any size block gc memory card? like a official 59 block for example?
and should my wire be short and IDE?
thanx
I'm getting very encouraged by my ds lite mod i recently did and im also working on a new way to finish my GCP.
um, i was looking at ashen's diagrams for the gc memroy card + micro sd adpter:
GC Memorycard pinout & notes:
Pin #'s shown coincide with the pin #'s printed on top of the GC motherboard.
SD Gecko pinout & signal's:
Pin #'s shown are SD card pin #'s. When wiring to GC match up signals only! INT signal is only needed on pin 9 IF you plan to make up a microSD to GC adapter as shown below. If you don't care about this feature, then the INT signal is not needed for SD Gecko operation.
and im thinking of making a gc memcard <=> Micro SD adapter mod as my sd card i use for homebrew/swiss related is a micro sd 32gb card.
anyways, about soldering the pins of both cards together using ashen's diagrams,
i solder the pins like so:
SD adapter = GC mem
1 = 9
2 = 5
3 = 2
4 = 4 or 8?
5 = 11
6 = 10
7 = 7
8 = nothing
9 = 3
for the gc men card pins 12, 1, 6 i don't need to worry about as im not soldering it to the gc men port, right?
also, i can use any size block gc memory card? like a official 59 block for example?
and should my wire be short and IDE?
thanx
