Need help, no video output

[exp0wnster]

Hello everyone,

I have been working on a portable for awhile now, and i have the casework mostly finished. I have started on the electronics (clone genesis) and hooked it up too a screen and everything. but now it stopped sending a video signal (its around .2 volts?). I tested it on multiple TV's but nothing seems to work. the LED turns on but that's it.

Here's the board. I think it has to do with the cap on the right side of the back ( 2nd pic). it is connecting ground and power together, but the led lights up so i know there is a difference. Any thoughts?

Thanks

 

[bud]

From what I can tell, you have video and ground wired backwards. Try soldering video where you have ground, and ground where you have video.

Disregard what I said if it was working earlier then stopped. (meaning you haven't changed anything since it was working)

 

[exp0wnster]

video and ground are soldered in the right spot. the video output voltage is around .2 volts, could that be a problem? Im using the original power setup so energy shouldn't be a problem, unless it is slightly bridged somewhere