after doing the omgwtf trim on my pal cube, i soldered everything i needed to get it to run and display on my tv but i get some weird video problem
the edges might look a bit bad but there perfectly sanded with a air die grinder and was cut by it to
i couldnt get no display taking the video strait from the chip so i took it from here
also took my av cable apart to wire in the cap and resistor cause at first i only had a composite cable going strait from the cube to the tv but that gave me the same image it does with the cap added
taking composite ground from this
![DSCF9380.jpg](/proxy.php?image=http%3A%2F%2Fs9.postimage.org%2Fllpgynv27%2FDSCF9380.jpg&hash=5838eed2d3df20a2f59d9516f19b49ff)
the edges might look a bit bad but there perfectly sanded with a air die grinder and was cut by it to
![DSCF9376.jpg](/proxy.php?image=http%3A%2F%2Fs9.postimage.org%2Ftambadvjz%2FDSCF9376.jpg&hash=4294917b248e405296d721047ef3324d)
i couldnt get no display taking the video strait from the chip so i took it from here
![DSCF9377.jpg](/proxy.php?image=http%3A%2F%2Fs9.postimage.org%2Flvwzi09of%2FDSCF9377.jpg&hash=2c63a6f5f510847ca6e142224f9fd614)
also took my av cable apart to wire in the cap and resistor cause at first i only had a composite cable going strait from the cube to the tv but that gave me the same image it does with the cap added
![DSCF9378.jpg](/proxy.php?image=http%3A%2F%2Fs9.postimage.org%2Fnc8i05clb%2FDSCF9378.jpg&hash=a0f53b766cc46d7c782e23a0aa4efd4f)
taking composite ground from this
![DSCF9382.jpg](/proxy.php?image=http%3A%2F%2Fs9.postimage.org%2F6r5gy8av3%2FDSCF9382.jpg&hash=c84b5209e1e7cb2c5b61182e81ea6a61)