pinout for the back of psone screen

[bentomo]

I was wondering if anyone has a guide for the psone screen for directly attaching video, audio, headphone, etc. to the back of the psone board rather than the bottom of the board.

I can't find one, anyone know where one is?

 

[epicelite]

Should be one on bac/bibin/whoever writes all those tuts site.

 

[eurddrue]

Should be one on Bacteria/bibin/whoever writes all those tuts site.

There's one on benheck. :whistle:

 

[bentomo]

Thanks bacteria, but does that work for the ntsc american version?

 

[themadhacker]

Actually on the verge screen everything (not counting RGB) is soldered directly to the back of the screen.

 

[Basement_Modder]

Thanks bacteria, but does that work for the ntsc american version?

I might be wrong, but I think the only difference between the PAL and NTSC boards are a few components in the mid-upper part of the board. I will know for sure if the same pinout works on an NTSC screen when I get to do the RetroDuo project.

That is correct. The PAL screen has one additional chip that the NTSC version doesn't, but it is not required for the wiring in those diagrams.