N64p almost done or not

My led wont turn on in the n64......... :cry4:
Is a 2.2k 1/2watt 5% tolerance good enough for the pth8080?
Im using 2 3.7v batteries 5Ah from battery space what charger is good?
@first question obviously get a new one :dah:
 
The resistor is fine.

Was it working before?
Are you sure you were getting 3.3v?
Is it wired right?
 
I think before i wired everything i fried the board and just another question is the memory stored in the game or jumper/expansion pack because im thinking of upgrading but i dont want to lose my game progress
 
If the LED doesn't turn on, you have a short somewhere on your board or you are not feeding it the proper 3.3v. The LED is fed direct from the 3.3v line IIRC and will turn on even if the board is fried. Check your input voltage. If it's right, look on the board for solder blobs or little strands of wire that may be connecting ground and power.
 
Back
Top