Tchay
Frequent Poster
GC motherboard, Revision A/B NTSC
Side A - outer layer (some of the inner layer has been exposed)
Side B - outer layer
Trimming Guide (side A)
Green = Beginner Possible (with sound relocation)
Red = Intermediate Possible (with sound relocation and relocating 3.4v line from power pins)
Blue = Experienced Possible (still testing, needs sound relocation + voltage relocation. Possibility of sound and mem card not working. Depends on mobo)
Purple = BAMF Theoretical (voltage relocation obviously. But not much else probably)
Assuming trace latency was not an issue, you could essentially relocate the entire board and cut it into many pieces. As long as the 4 different voltages and ground got to their proper components and everything was wired properly, the board would work.
Forgive my shooping skills. I have yet to get photoshop on my mac.
I'll add scans of the inner layers in a week or so
thank Beta
Side A - outer layer (some of the inner layer has been exposed)
Side B - outer layer
Trimming Guide (side A)
Green = Beginner Possible (with sound relocation)
Red = Intermediate Possible (with sound relocation and relocating 3.4v line from power pins)
Blue = Experienced Possible (still testing, needs sound relocation + voltage relocation. Possibility of sound and mem card not working. Depends on mobo)
Purple = BAMF Theoretical (voltage relocation obviously. But not much else probably)
Assuming trace latency was not an issue, you could essentially relocate the entire board and cut it into many pieces. As long as the 4 different voltages and ground got to their proper components and everything was wired properly, the board would work.
Forgive my shooping skills. I have yet to get photoshop on my mac.
I'll add scans of the inner layers in a week or so
thank Beta