any reason why this cut board isn't workin? Rev. C

[Joeyjoe9876]

Cut it using the rev.c guide, and actually cut less than ashen did in his picture. wired up power and for some reason it isn't turning on, any ideas? sanded the edges of the board to make sure that the layers were not touching.

 

[SonyQrio]

Make sure to check for shorts where you cut the board. Sand it down and test it again.

 

[Ashen]

What are you using to power it? Are you sure the regulator you're trying to use works? Do the chips get warm? Where are you pulling video from?

 

[Joeyjoe9876]

never mind, got it working! don't actually think anything was wrong, but I pulled video straight from the chip instead of the capacitor and it came right up! probably should have tried that before making a thread haha.