Zenloc Custom Regulator

[Bakuku]

Hi all,

So I got my PTR08100 and both PTH08080 boards for the custom regulator.
But Zenloc mentiones that he uses 1.87 , 903 and a 348 resisitor. The sales man in the store only had 1.8 , 910 and 430 as the closest values. Will they do or should I die a little inside today?
Also, I can't read the Assembly diagram

Thanks In Advance.
Greets, Bakuku

 

[Ashen]

The 910 and 1.8 will probably be ok, the 430 might be pushing it though. Wire them up and check the voltage output with a mulitmeter to see how close you are to the target voltage.

You can string together resistors to get the values you need. For example, a 200ohm and a 150ohm resistor wired in series will give you 350ohm.

 

[Bakuku]

The 910 and 1.8 will probably be ok, the 430 might be pushing it though. Wire them up and check the voltage output with a mulitmeter to see how close you are to the target voltage.

You can string together resistors to get the values you need. For example, a 200ohm and a 150ohm resistor wired in series will give you 350ohm.

Thanks Ashen for the quik reply.

With series you mean just adding resisitors in a single line by wich i mean connecting one end to the beginning of the other, right?

thanks

 

[Ashen]

Yes.