the really last poblem i have ...Z

[RaAaK the FoX]

Z ..zurg ?
so here I wanted to move the Z button, then i desoldering the original I extended with two wire soldered onto the board ... my problem ... it does not work .. I do not know why SIAS (I know this is normally the easiest thing to do .. but good with the talent I have ...-_-) so that you advise me .. ca find scratch marks on the map then welded or is there another method?

 

[RaAaK the FoX]

i can post picture if u dont understand ..

 

[superben51]

Yes, please do.

 

[RaAaK the FoX]

it's the original buton (4pin) i have conect only 2 for moment

 

[Prog]

You need to upload them somewhere, IE imgur.

 

[RaAaK the FoX]

http://sta.sh/21cqswp9fj0k?edit=1 all in one here

 

[RaAaK the FoX]

actually 2/4 pin of the official buton z are connected to the controller motherboard

 

[superben51]

Just out of curiosity, have you tried desoldering the wires and just touching them together?

 

[RaAaK the FoX]

yes and that dddnt work /:

 

[Diminuendo]

why do you have 4 wires going to the tact switch, you should only need 2.

also, when taking photos focus is your friend.

 

[RaAaK the FoX]

this why i post here -_-' i dont no !!! it's my question ! why that dont work ,i have already try with 2 and 4 -_-' pin wired, in both cases, nothing happens