Hi,
I got a nintendo 64 that is trimmed . It is a rev between 5 and 9 and it is trimmed with the bud trimming guide. I tested the board before trimming and everything was working perfectly. Now i did the resistor fix because it didn't power up when plugging it but now there seem to be a voltage problem . My regulator is giving 3,3v as supposed but when i plug it to my nintendo 64 it give 3v instead of 3,3 . I tried with an official nintendo power brick but the result is the same . I don't know if this is causing the console to be not working but this must have a link . Did someone had this problem before? If so how did you solve it ? .
Thank you
PS: sorry for my bad english
Edit: Nevermind i found the problem . All i had to do was to remove the u8 chip and use the controller connection on the pif chip .
I got a nintendo 64 that is trimmed . It is a rev between 5 and 9 and it is trimmed with the bud trimming guide. I tested the board before trimming and everything was working perfectly. Now i did the resistor fix because it didn't power up when plugging it but now there seem to be a voltage problem . My regulator is giving 3,3v as supposed but when i plug it to my nintendo 64 it give 3v instead of 3,3 . I tried with an official nintendo power brick but the result is the same . I don't know if this is causing the console to be not working but this must have a link . Did someone had this problem before? If so how did you solve it ? .
Thank you
PS: sorry for my bad english
Edit: Nevermind i found the problem . All i had to do was to remove the u8 chip and use the controller connection on the pif chip .
