Pyroburner69
Newb
Guess this will be my working log but I have a few questions I will preface with with.
First off I was wondering if anyone has removed a soldered in cart slot without damaging the PCB. I would like to move the cart slot. On that note does anyone know where I can get a replacement cart slot? I'm wondering if it would be best for me to buy a broken one and hack up the PCB to get a slot.
Right now I have a the system and display working off of 5.12vdc (this is what my batter charger is outputting.)
The entire setup is pulling 700mA right now. I am not running an amp currently just pulling the audio right from the Snes and using it to drive my headphones. I will either add an amp later or at least a volume pot.
I'm using a battery charger similar but not identical to
http://www.amazon.com/RAVPower-Portable ... B00MNAWMHE
I will go bigger if I have room in the case. I am hoping for at least 10Ah with a pass through so I can play and charge at the same time.
Also I am wondering if anyone has any recommendations for adhesive as I am going to be cutting up a snes controller and building it into a case.
If there is any interest I will add images.
Thanks
First off I was wondering if anyone has removed a soldered in cart slot without damaging the PCB. I would like to move the cart slot. On that note does anyone know where I can get a replacement cart slot? I'm wondering if it would be best for me to buy a broken one and hack up the PCB to get a slot.
Right now I have a the system and display working off of 5.12vdc (this is what my batter charger is outputting.)
The entire setup is pulling 700mA right now. I am not running an amp currently just pulling the audio right from the Snes and using it to drive my headphones. I will either add an amp later or at least a volume pot.
I'm using a battery charger similar but not identical to
http://www.amazon.com/RAVPower-Portable ... B00MNAWMHE
I will go bigger if I have room in the case. I am hoping for at least 10Ah with a pass through so I can play and charge at the same time.
Also I am wondering if anyone has any recommendations for adhesive as I am going to be cutting up a snes controller and building it into a case.
If there is any interest I will add images.
Thanks
