GamecubePerson111
Active Member
I've looked around, but cannot find any info on how the R trigger on the GC controller would be relocated, any help would be greatly appreciated, Thanks.
GC R trigger rewiring
- Thread starter GamecubePerson111
- Start date
Jidan
JEEEEEEEEDAN
I don't have any pictures right now, but the triggers are a button and a potentiometer. In total you're going to have 5 wires for each trigger: two for the button, and 3 for the potentiometer. This thread by hailrazer should help explain it pretty well for the most part.
http://forums.modretro.com/viewtopic.php?f=3&t=1160&start=10
EDIT: A bit more helpful. The button is pretty easy to find for them; it's that thing that sticks off of the controller perpendicularly and is connected by two wires. The potentiometer is that sliding thing surrounded by the metal frame mounted on the controller, and I think it has three solderings towards the inner part of the board. I'll bet you could find some pictures around here if you looked hard enough. ^^;;
http://forums.modretro.com/viewtopic.php?f=3&t=1160&start=10
EDIT: A bit more helpful. The button is pretty easy to find for them; it's that thing that sticks off of the controller perpendicularly and is connected by two wires. The potentiometer is that sliding thing surrounded by the metal frame mounted on the controller, and I think it has three solderings towards the inner part of the board. I'll bet you could find some pictures around here if you looked hard enough. ^^;;
GamecubePerson111
Active Member
Thanks, I actually got the pentiometer just wired to a tact switch with only 2 wires, but thanks for your help.
GamecubePerson111
Active Member
Well there's the top three holes where the pentiometer connects on the board. I used pins one and three and wired to a tact switch and it worked for me.
