Controller Problems

[8BrickDMG]

Hi there all, basically I'm having a problem with my gamecube motherboard as it
doesn't pick up my controller for P1 and I've wired to this as I've done the AlmostWTFCut.

All I have going to the controller is: 3.3v, Data and Ground

Does anyone know why this is?

 

[Ashen]

What controller are you using? Some 3rd party controllers require the 5v line.

 

[8BrickDMG]

I've been using the Classic Controller, It worked fine before when I wired it to the Max Motherboard Cut Relocation though

 

[Ashen]

Classic controller should work, can you post pics of your connections?

 

[8BrickDMG]

I'll take some pictures of it now for you, won't be long

 

[8BrickDMG]

Sorry about the picture quality and pictures themselves, I could only use my iPhone
http://www.flickr.com/photos/jasonaquin ... 596064367/
http://www.flickr.com/photos/jasonaquin ... 596064051/
http://www.flickr.com/photos/jasonaquin ... 596063185/

 

[8BrickDMG]

Sorry to triple post and bump this thread like a noob, but I just tested my controller and it works with my Wii but I'm puzzled with why it won't work with the cube. I'm using a PAL CPU-01 board if that helps.

 

[Rbby258]

Having the same problem with my omgwtf trim pal board even connected every wire to one of the ports and no luck

 

[8BrickDMG]

Since I posted all this I haven't been able to fix it. I tried every port like you did, tested the controller with my Wii and it wasn't that. In the end I gave up. I may try with a new board one day unless somehow it starts working again.

 

[MoRZiLLo]

Sorry man. Have you tried to bridge two pins 3 and 4 for ground?
This is for got rumble when you cut your board, but works. Try it before you buy new board.

Good Luck!