blue_stalfos's N64P work-log

[blue_stalfos]

its not dead its just useless. i meant i stripped the wire too long.

 

[metalblank]

well just use some different wire it should work

 

[metalblank]

or just shorten that wire

 

[S5114]

^^ that's a double post, don't do that. Use the edit button. Anyway, yeah I mean. flax, your wires are LONG, as metal said, keep them short, and don't throw that board away, just swap out the wires.

 

[blue_stalfos]

Would someone be so kind as to direct me to the step down regulator on ti.com?

 

[ToastBucket]

There are two you can use. Both do the same thing, just are wired up differently.

PTH08080

PTH08000


Personally I like the PTH08000 better.

 

[bud]

I've had better luck with the 08080. It's also smaller.

 

[ToastBucket]

You've had poor luck with the 08000? It's the only one I've used and It's never not worked for me.

 

[blue_stalfos]

my bad

 

[Noah]

There is one.

 

[blue_stalfos]

PTH08080WAD?
PTH08080WAH?
PTH08080WAS?
More specific? or does it not matter?

 

[brunoip]

PTH08080WAD?
PTH08080WAH?
PTH08080WAS?
More specific? or does it not matter?

they are all the same

 

[bud]

Go with the WAH or the WAS. The other ones have through hole pins on the bottom. You don't want that.

 

[ToastBucket]

Go with the WAH or the WAS. The other ones have through hole pins on the bottom. You don't want that.

They're not that difficult to remove Although yeah, if you get the WAH or WAS, you don't have to worry about them at all.

 

[Hackerbilly]

The WAH has big long pins at the bottum. What are you talking about?
But if you want to remove them, Put your soldering iron on them and they will come straight off.

 

[blue_stalfos]

Finally, after 3 failures a SUCCESS! looks neat too

 

[ShockSlayer]

Nippletastic!

 

[blue_stalfos]

I Need some help with my case. I can't figure out how to mount the screen on the system like ss's 11th and could use some help.

 

[bud]

For the screen, I'd screw the back plastic piece to the case. Then reassemble the screen normally.

 

[blue_stalfos]

Would it be ok if I used a 22ohm resistor instead of a 20ohm resistor for the screen mod?