Hello! I finally got back into building my portable and I have run into a slight confusion.
A few members from another forum have informed me that when you use Swiss autoboot you must set your wiikey to PAL (on, on, on, on) instead of NTSC (off, on, on, on) even if your cube is NTSC.
However I've seen a few threads here stating you must use the same wiikey region setting as the cube that is being modded.
So what is the deal?
What is the correct region setting for a Swiss autoboot flashed Wiikey with a made in japan IPL v1.0 NTSC-USA gamecube?
It will be a portable cube, no disc drive
On a side note: is there any other guides on the soldering process for the wiikey? Or is this the only one? (GC forever link, not sure if I can post)
A few members from another forum have informed me that when you use Swiss autoboot you must set your wiikey to PAL (on, on, on, on) instead of NTSC (off, on, on, on) even if your cube is NTSC.
However I've seen a few threads here stating you must use the same wiikey region setting as the cube that is being modded.
So what is the deal?
What is the correct region setting for a Swiss autoboot flashed Wiikey with a made in japan IPL v1.0 NTSC-USA gamecube?
It will be a portable cube, no disc drive
On a side note: is there any other guides on the soldering process for the wiikey? Or is this the only one? (GC forever link, not sure if I can post)