cheese
Member
Bought (preordered) a 3d printer from phoenix 3d/ez3d in July. The company died, 200$ down the drain 
.
In November I bought a Prusa i3x kit. Got it the next month, built it, found it had a dead mobo... woo.
Finally got a replacement from the seller, and it has had very few breaks since
Click pics for full size version ^-^
I keep it set up in a corner of my room, and it has a convenient screen that I just slap a SD card with some .gcode on it and away it goes
Sample prints:
0.35mm layer height, supports, raft enabled
0.25mm layer height, 0.35mm initial, supports, raft enabled
0.25mm layer height, 0.35mm initial, no supports, no raft
.In November I bought a Prusa i3x kit. Got it the next month, built it, found it had a dead mobo... woo.
Finally got a replacement from the seller, and it has had very few breaks since
Click pics for full size version ^-^
I keep it set up in a corner of my room, and it has a convenient screen that I just slap a SD card with some .gcode on it and away it goes
Sample prints:
0.35mm layer height, supports, raft enabled
0.25mm layer height, 0.35mm initial, supports, raft enabled
0.25mm layer height, 0.35mm initial, no supports, no raft
