Recent content by bentomo

Re: Dyxlesci's Wii Super Thread Some of the boards I tested with just a disc drive connected also need the disc drive board to have the power cable attached to load games.

Re: Dyxlesci's Wii Super Thread You're welcome. :wink:

Re: Dyxlesci's Wii Super Thread Yea that's what I mean, it may be powering the usb device but no the 5v logic of the system. So I'll need to figure out where the power is being sent through.

Re: Dyxlesci's Wii Super Thread I have thought of trying that but I want to know more about the internal layers first before I start hooking up more voltages. I tried attaching 5v directly to the USB 5v pin but the fat system still didn't seem to mount. Honestly I didn't do that much testing...

Re: Dyxlesci's Wii Super Thread I got my new preheating station. I've succesfully removed and documented all of the power supply components on the front and back of the Wii motherboard rev4-A. The Wii still runs just fine on the 1.2v and 3.3v line. This knocks out over 150 components from...

Re: Dyxlesci's Wii Super Thread I got the Wii running on custom regulators. I used a PTH08080 for the 3.3v line, and a PTR08100 for the 1.2v line. I had to bump up the 1.2v line to 1.3v to account for the voltage drop under load. The Wii draws between 700-800mA from a 12v source in the...

Not really, a lot of work is already going into compiling everything into the stickies. This isn't limited to the moderators either, if you have a recommendation for the sticky, PM a mod.

Nice job once again! What's your preferred retailer for the lcd? Alibaba?

NEAT!

I really don't see the intention of this. Your forum seems to have the same content as modretro. It seems as the only purpose this would have is drawing users to another forum for the same information and confusing people. If you just want to save the information for later use you can use...

The official one is the smallest you'll find. The third party ones actually just use 2 2mb chips and are twice the size so don't bother. A ram swap would be best because a jumper pay is the smallest. But if you have no desoldering experience this will be a challenge.

You didn't happen to take any pics of the case work before painting did you? We like the dirty bits here. :wink:

Swiss does not support the wii, sorry. You have to use the stock firmware.

Are those button guards tall enough to account for the depression distance on your average tact switch?

Now that is a sexy portable.