wiikey fusion on gamecube!

[jrikard0]

Hi, I did a bad update in my wiikey fusion, I read on the official blog that you can retrieve with a recovery disk that they you facilitate page, and have to put the wiikey fusion in a wii, if I have wii but the wiikey fusion this connected to a gamecube and to connect it I had to mutilate the original zif the wiikey(the flexible cable original White with blue that comes in the wiiekey), my question is how I am going to connect this on the wii? Best regards!!

 

[Bakuku]

There where you Cut open the Ribbon Cable, extend those parts and solder them directly to the correct pinout on the wii board.

This will require you to open your wii console and maybe remove the clamp to hold the cable in place. Or you could just get a new ribbon cable with the exact amount of pins as the original one. Or use the one from your OLD PS3 FAT I think

Regards.

 

[jrikard0]

There where you Cut open the Ribbon Cable, extend those parts and solder them directly to the correct pinout on the wii board.

This will require you to open your wii console and maybe remove the clamp to hold the cable in place. Or you could just get a new ribbon cable with the exact amount of pins as the original one. Or use the one from your OLD PS3 FAT I think

Regards.

I can not simply connect it without reader?

 

[megalomaniac]

You can use the recovery flash with WKF connected to the Gamecube.
Just insert the properly formatted recovery sd card into the WKF slot and boot up the Gamecube...

 

[jrikard0]

You can use the recovery flash with WKF connected to the Gamecube.
Just insert the properly formatted recovery sd card into the WKF slot and boot up the Gamecube...

yes but when he launched the "eject wii button' of the gamecube the normally closed, the gamecube is frozen, any solution? This happened when trying to install Swiss

 

[Bakuku]

What?

 

[jrikard0]

hi, already fix it, thank's for your help!