Where to solder 3.3v and ground on a WASP?

[RageCreation]

I've wired up an FCC cable using Ashen's tutorial, but his was done on an original Wiikey. On a WASP, there is much less surface area and a different layout.

Could anyone tell me where to wire 3.3v and ground on the WASP?

 

[DuHasst0]

If you have a multimeter, pin 32 is power, and that is located on one of those resistors next to the host ffc connector. Ground is to the left and right of any ffc connector.

 

[megalomaniac]

http://www.gc-forever.com/wiki/index.php?title=WASP_Fusion

i suggest the small cap at the bottom left or the big cap at top/center left

 

[Aurelio]

The red dots are directly connected to pin 32, so they are 3.3v, while for GND you can scrape a bit of the black are

 

[RageCreation]

The red dots are directly connected to pin 32, so they are 3.3v, while for GND you can scrape a bit of the black are

I'd prefer to keep everything on the top side of the WASP. It would simply work better in my case.

http://www.gc-forever.com/wiki/index.php?title=WASP_Fusion

i suggest the small cap at the bottom left or the big cap at top/center left

Just to confirm, would this work?

 

[megalomaniac]

why scratch off soldermask for GND when there are many GNDs available??
see the metal tabs on the sides of the FFC connectors? wanna guess what type of signal those are connected to?

 

[RageCreation]

Thanks!