Wasp fusion problem

[zacharypina]

I've run into a problem with my wasp fusion. The blue light turns on but the gamecube doesn't load the linux program. What could be wrong?

 

[Ampz]

You should probably check the wires and the connector pins for continuity.

 

[megalomaniac]

with the blue light flashing and if there is no error message, then chances are you might have the main contacts wired correctly..

did you add a lid switch? if you go to gameplay menu do you see a question mark?

 

[PSIDuck]

Check the pin 23 wire, a loose cable can cause the problem

 

[megalomaniac]

Check the pin 23 wire, a loose cable can cause the problem

FYI, pin23 is the lid connection for adding an optional switch as i have mentioned above

 

[zacharypina]

Thank you for all the replies and advice. I have bought a megadrive V5 and have successfully gotten linux to boot but when the wiikey screen loads it freezes. What could be the problem?

 

[Blargaman91]

What does it say when it freezes? If it's "Init Wiikey Fusion" or something similar then the formatting of your SD card is not correct or there is a problem with your SD slot.

 

[zacharypina]

The cursor won't move or anything. I am using a wave bird would that have anything to do with it?