The WowItActuallyWorked64 (previously N64Boy Advance.0)

So This is my project. I realize I've been pretty shaky about the whole thing. I usually just post links to images with no info. I know I said I was going to quit last year, but I did not! I returned in December, and I have practically completed it! Give me you reviews! I've fried 1 of everything, and I even bought another case and re-did that. It's been so much work and the budget has been expanded so much, but it's whatever. Here ya go!

DSC01550_zps3ec67feb.jpg

This is the face of the case. Pretty proud of the case overall.
DSC01551_zps2b7f2d90.jpg

Top. For my new buttons.
DSC01552_zpsfa8fe460.jpg

Volume amp with volume control tact switches and headphone jack.
DSC01553_zpsa21759ae.jpg

DSC01554_zpseb9176ba.jpg

controller board
DSC01555_zps8c1edc67.jpg

It works!
 
A little update: I just bought a dpdt switch and when it arrives I'm sending it off to bud and he's gonna wire up the power. After that all I'll have to do is assemble it!
 
Well I got it back from bud. He did good work. The joystick doesn't work, so I bought a new GameCube controller. Hopefully I'll get it to work, and the be completely finished!




I have 2 7.4V 2500 mAh Li-ions. I'm pretty sure that they're Sony brand. Can anyone tell me how long it will take to charge them? or how long they'll last?
 
From what I have been reading them battery's should last around 2-3 hours and take the same time to charge, but that depends on your charger. Someone correct me if I am wrong. I'm jealous of your golden OOT! I want one so bad...
 
Wowitactuallyworked is easily one of my favourite usernames on here lately.

Some good work so far, although the cartridge port looks a little high up, does the cartridge have much support against crashing with so much of it exposed?
 
CopperBrute said:
From what I have been reading them battery's should last around 2-3 hours and take the same time to charge, but that depends on your charger. Someone correct me if I am wrong. I'm jealous of your golden OOT! I want one so bad...
Thanks. Btw I got it for the small amount of $23 bucks!
 
Well I re-did it. The results are:
Up: doesn't work
Down: moves character up and to the right, slowly
Left: sprints right, but when pressed hard, character stops
Right: kinda wags out.
Sometimes the character will just not stop sprinting in a right circle
So what should I do?




from left to right on the board pins go 4,3,2, and 1
on the joystick you can see pin one and the two pins above that are bridged and number 2
on the top, far right you can see 3 and the two to the left of that are bridged and number 4
 
I'm re-doing the controller: I got a new one, and long story short, I chopped some wires hastily and I forgot what's what.


That's the bottom right-hand corner of the motherboard. Which ones are power, data, and ground?
 
Back
Top