ToastBucket tost hi Jul 21, 2010 #1 Ill trim the board beforehand. I would do it myself but I don't know if I'm good enough yet. Make offers.
Ill trim the board beforehand. I would do it myself but I don't know if I'm good enough yet. Make offers.
BoFoSho Frequent Poster Jul 21, 2010 #2 If I get back into the RCP groove, Julian and I will charge about $75 that includes trimming and shipping.
If I get back into the RCP groove, Julian and I will charge about $75 that includes trimming and shipping.
ToastBucket tost hi Jul 21, 2010 #3 Hmmmm. Ill try to rustle up that. If I can't get that much though, how much would you charge if I did the trimming and stuff?
Hmmmm. Ill try to rustle up that. If I can't get that much though, how much would you charge if I did the trimming and stuff?
BoFoSho Frequent Poster Jul 21, 2010 #9 What do you mean, I am going to get the RCP wiring supplies tomorrow. I admit I wasn't willing too/couldn't before but now I'm in the RCPin' mood.
What do you mean, I am going to get the RCP wiring supplies tomorrow. I admit I wasn't willing too/couldn't before but now I'm in the RCPin' mood.
Basement_Modder He who mods in thy basement. Jul 21, 2010 #12 Snow, I saw your board at MRCT. You know, the dead one? It looked like the cart slot relocation was soldered by a dipflax 5th grader holding the iron with his mouth. Just sayin'
Snow, I saw your board at MRCT. You know, the dead one? It looked like the cart slot relocation was soldered by a dipflax 5th grader holding the iron with his mouth. Just sayin'