So I tried making a gc video the other day and managed to make two. I have a HW-USBN-2B to program and very little knowledge to program with. After getting everything soldered and connected to all of the pins on the motherboard I flashed the firmware with the .jed file. It said it was successful. However connected to the screen (http://www.good-display.com/products_detail/&productId=128.html) it was black, but it was sensing video since I no longer had the sync image error on the screen. It looked like it worked but like I said, no video. I've tested this board with composite video and I know it works.
I made the other board with the exact parts that was listed on the board, pdf, etc. Same problem.
For the digital pins they are 1:1 like what was mentioned. Pin 1 goes to the square pad on the gcvideo and then so on till the end.
Can anyone tell me what I'm doing wrong and how do I fix it.
I made the other board with the exact parts that was listed on the board, pdf, etc. Same problem.
For the digital pins they are 1:1 like what was mentioned. Pin 1 goes to the square pad on the gcvideo and then so on till the end.
Can anyone tell me what I'm doing wrong and how do I fix it.
I plan on just using composite then retro fitting a new panel with component after the fact so I can wait.
