[N64 Portable] What screen?

[RetroNuva10]

Hey. It's been a while since I've posted anything related to my N64P (Or related to anything else for that matter..)

I am not sure what screen to use for my portable. I'm using a Wii U Gamepad protective case (Gonna' use leftover plastic from the N64 console to patch up spots with holes) for my portable. I want the screen to be larger than 4.0" and less than 5.3". As long as it's close to those measurements, it'll most likely work. Apparently -- It needs to support Composite input, and has to run off 7.4 volts.

Thanks!


Cheers,
-Ben.

 

[Bush]

Are you sure you want to use that small of a screen? You can get a 6.2" off ebay that will fit the space, no filling necessary.

 

[RetroNuva10]

Are you sure you want to use that small of a screen? You can get a 6.2" off ebay that will fit the space, no filling necessary.

That's actually a good idea. I'll look into getting one. If you of any 6.2" screens that work with N64P's -- Please give the link.

 

[watsug]

If you use one of the ebay 5" sceens, the screen bezel fit pretty snugly in the screen hole. Plus they're cheap.

 

[Bush]

http://www.ebay.com/itm/370933454855?_t ... EBIDX%3AIT

A little pricy but it will fit the hole pretty well. Also has VGA in if you feel like doing RGB. I used this on my last portable and it's not bad by any means.

 

[RetroNuva10]

http://www.ebay.com/itm/370933454855?_trksid=p2060778.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT

A little pricy but it will fit the hole pretty well. Also has VGA in if you feel like doing RGB. I used this on my last portable and it's not bad by any means.

Thanks -- But I found one I like It's 5"

http://www.amazon.com/Monitor-Parki...m_sbs_e_3?ie=UTF8&refRID=1MBRK97P92GVQEKNGRXF

http://www.ebay.com/itm/370933454855?_trksid=p2060778.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT

A little pricy but it will fit the hole pretty well. Also has VGA in if you feel like doing RGB. I used this on my last portable and it's not bad by any means.