N64 board bending help

[orangeziggy84]

My board won't show a picture or have sound after I bent it. It was working before I bent it. In the middle of cutting it I turned it on and it also didn't work. Any help?

 

[Elektix]

You need to reconnect the 3.3v line to the correct pins.
Also the 12v line.

and I would imagine ground aswell.

If you look at the RCP wiring diagram in the megasticky, it shows which pins do what.

ensure you connect your power lines to the right places, or you'll brick your board.

 

[ShockSlayer]

You need to reconnect the 3.3v line to the correct pins.
Also the 12v line.

 

[orangeziggy84]

It still doesn't work, though...

 

[ttsgeb]

check continuity across all of the lines. It's possible you broke one during the bend and you can't really tell by looking.

 

[orangeziggy84]

Would it be best to rewire everything, then?

 

[vskid3]

Or, to save time and only have to fix what is broken,

check continuity across all of the lines. It's possible you broke one during the bend and you can't really tell by looking.