Bino Gas Active Member Nov 22, 2010 #1 I broke a lead off of one of the caps. What should I replace it with? Image belongs to Zenloc.
Bino Gas Active Member Nov 23, 2010 #3 I removed it temporarily, but part of the cap was still on the board. I could have been more careful.
I removed it temporarily, but part of the cap was still on the board. I could have been more careful.
Bino Gas Active Member Nov 24, 2010 #4 Well, I found a pinout of the chip (JRC NJM2284) that capacitor is connected to. It's used to switch video signals. In the datasheet, the test circuit shows a 10uf cap connected to pin 8, which is what I need. So I guess I solved my own problem.
Well, I found a pinout of the chip (JRC NJM2284) that capacitor is connected to. It's used to switch video signals. In the datasheet, the test circuit shows a 10uf cap connected to pin 8, which is what I need. So I guess I solved my own problem.
