N64 Trace

[E64]

the gray lines is where I trimmed my board the problem is the dark red line is where I messed up at is there a way to fix this if so let me kno thanks

 

[supersonic_32]

Really easy to fix in fact, just compare your board to those scans: (top and bottom)

If you cutted through traces that you shouldn't have, you only have to scratch the light green trace with a knife or something to reach the copper each side of where you cutted, than solder a wire from point A to point B than tadam! You just repaired the trace with a wire instead of the original copper trace.

 

[E64]

I have try that even used flux but it won't stick

 

[supersonic_32]

If you scratch the green enough it's suppose to stick, just try to heat that part of your board with your soldering iron before trying to solder.