Atari 2600 in an OKW case.

[desmin88]

I waited about 5 days for my OKW case. I was going to put my Atari 2600 in it, but upon arriving, I discovered the dimensions are 5ish inches by 3ish inches. When i ordered an XL size I thoughtd it be a bit bigger than this

Is there any other way to cut up a 2600 in a 4 x 3-1/4 instead of 4x4?


Thanks

 

[Tibia]

I don't have a 2600 in my possession right now, but I seem to recall it would be possible to relocate things a little bit. Ben once got a junior (pretty much same 4" square as a 4-switch) down to under 3" square. It will require wiring stuff to chips and other spots, though. I wish I had more info for you.

 

[snowpenguin]

:/

This is like the 15th thread from you about how small you can get a 2600 or fb2. :/

 

[desmin88]

Sorry about that.

I just wanna make certain it will fit so I dont have to get more cases.

 

[Joeyjoe9876]

On a 2600 if you cut it up a bit you can fit it in one.

if you cut along the red lines and rewired a few things and wired the cart slot directly to the chips you could fit it most likely.

 

[Basement_Modder]

You will also have to relocate some components.

 

[bic]

A Flashback 2 will fit in that size space, and it can run most 2600 cartridges if you add a slot.

 

[Basement_Modder]

Adding a slot to a FB2 is a little risky for a beginner...