Ampz Active Member May 28, 2015 #1 Is it possible on the 3rd party gc controller to use the actual parts of the controller in different parts of a GC portable case? like wiring the traces of the board to the other or something else.
Is it possible on the 3rd party gc controller to use the actual parts of the controller in different parts of a GC portable case? like wiring the traces of the board to the other or something else.
Pinotte Member May 28, 2015 #2 Yes, just cut out the part of the board you need and reconnect all the traces by rasping.
Ampz Active Member May 28, 2015 #3 Oh ok I wasn't sure if could just rasp at the traces and just solder wires thanks for the reassurance!
Oh ok I wasn't sure if could just rasp at the traces and just solder wires thanks for the reassurance!
X xy007 Member May 28, 2015 #4 Yeah I will be doing the same thing this week, I think I will end up using two controllers green boards.
Yeah I will be doing the same thing this week, I think I will end up using two controllers green boards.
