Recent content by McBlasian

Hi guys. I want to trim the n64 controller down for a project I'm thinking about but need your help. Here's where I want to trim it: but I guess I'll need to reconnect the ground across where I've trimmed? If anyone could edit the picture to show where to reconnect the ground that would be...

Pretty much what the title says.

Yeah it does run off of 3V normally. I was wondering if anyone knew if adverse affects occurred if you chucked 5V into it instead. Thanks!

I was thinking of getting this (http://www.amazon.com/3-5mm-Barrel-Jack ... +usb+cable) to run the gameboy off a usb.

Is the n64 games, the n64, or the NES a PAL unit, by any chance?

You are a lifesaver. Thanks Beta.

Would a PTH8000 get it at 3v?

Should I use a step down regulator, or a resistor?

Beta, why should I be using that resistor instead of the 1.87k one?

Thanks so much for the help! Sorry I didn't understand the diagram. If the 'karma' feature was still around I'd definitely plus you heaps haha!

Oh, I get it! So the red and black wires are from the laser, yes? So how do I wire the usb to the pth08080w?

Sorry Beta, I don't understand how to wire the regulator correctly. All I need from the USB is the 5V and the ground, yes? And I can ignore the other two connections. Then from there, which wire goes straight to the regulator and which goes to the resistor then to the regulator? Lastly, where...

Thanks heaps. Would you be able to quickly explain where to wire each component? I am very new to this. On a side note, isn't that the regulator used in N64P's

Dang, I wanted to run a 3v green laser from it. How would I limit the power from a USB port?

How about when music is playing? Does it fluctuate greatly?