Recent content by BayCoder1

Actually Rage its mighty putty. Bondo would work the same. Usually I start by using a epoxy called plastic weld or something like it just to make sure that the part is secured well. Then I use bondo or in this case mighty putty to fill the major voids. Ideally u want something that is thicker...

Thanks guys! All it takes is time. Just fill, sand, paint, wet sand, and fill it agin. Then u repeat until it's all smooth. Blargaman I have both data and 3.3 main connected and still nothing. I'm going to try my other wiikey and let y'all know what happens, thanks for the help and compliments.

Thanks man!

Ok guys here's an update on my progress so far. I got some work done on the case and it is almost finished Here's the front And this is the back I'm also making good progress on the mobo. The only thing I have yet to do is wire the mem card and clean up the test wiring. I did run into a...

Here's what I got done this weekend. Before sanding After sanding with a quick coat of paint I still need to fill in some holes but it's getting there. I also cut my mobo, it's a rev c with a minimalist cut. I seem to flock things up when I go to small and since there is plenty of room in...

Ok guys I got the case and wow this thing is big. After getting a look at what this case looks like I think I have decided to continue to work on my other case and this one at the same time. This is the two side-by-side My plans for the new case If anyone has the back caseing of a psone...

I couldn't find where the original diagram was, but here is one that I quickly sketched.

Im almost positive the crystal has something to do with the time and/or date of the Gamecube. Now the Bios battery is wired to the chip that you relocate the crystal to, and I believe the positive of the Bios battery gets wired to the outer most pin, right next to where you have to relocate the...

Ok so I have realized that I need to rethink the size of this portable. With this being my first attempt it has proven to be a real challenge. I have gone through many gamecube mobos and a couple of wiikeys. I have decided to make this portable bigger than I was originally aiming for and once I...

Re: GameCude portable worklog Ok guys I rewired the wiikey on a different board (because I pulled up a tiny resistor on my other board and now it won't work) and I ran into another problem. When in the Swiss menu the controller will not work. I have no idea what's going on, I'm pretty confident...

Re: GameCude portable worklog I guess I'll try that next. :cry: Thanks for the reply.

Re: GameCude portable worklog I checked and rechecked the ribbon cables and I still get the same result. The epoxy I use is called plastic weld and it works great, although it's way harder to sand than JB weld it dose not crack like it. It's super strong and is perfect for Franken casing, but...

Re: GameCude portable worklog Hey guys, sorry I haven't posted any updates. I've been really busy with school and robotics, and now that robotics is over and school is winding down I've started to work a little on my gamecube. I wired my wiikey up today and can't figure out why it freezes at...

Ok thanks bro. And I designed it after yours.

I will now be selling this project as I have no time to Finnish it and no room for it. Pm me if your interested.