Need info on 3ds sliders
- Thread starter biofan1
- Start date
naimlessone
Active Member
Ebay, Amazon....
Did you look in the mega-sticky for info on using them??
Did you look in the mega-sticky for info on using them??
Miceeno
Member
Steer clear of the PSP sliders! Only buy 3DS ones!
You will also need some of these for adjustment:
http://www.ebay.com/itm/10pcs-5K-oh...691?pt=LH_DefaultDomain_0&hash=item51c2febe1b
I didn't check the mega sticky so if this is already in there than you guys can tell me off or whatever. Although last time I checked, when I was working on my portable, it took alot of searching (out side of the mega sticky) to find the good starting values for the pots required to make the stick work correctly so here they are:
3022 Ohms on the X
3525 Ohms on the Y
And of course a Super Pad controller.
You will also need some of these for adjustment:
http://www.ebay.com/itm/10pcs-5K-oh...691?pt=LH_DefaultDomain_0&hash=item51c2febe1b
I didn't check the mega sticky so if this is already in there than you guys can tell me off or whatever. Although last time I checked, when I was working on my portable, it took alot of searching (out side of the mega sticky) to find the good starting values for the pots required to make the stick work correctly so here they are:
3022 Ohms on the X
3525 Ohms on the Y
And of course a Super Pad controller.
naimlessone
Active Member
naimlessone
Active Member
Miceeno,
(I posted this in your worklog thread as well for you N64ortheWin)
I saw from your worklog from viewtopic.php?f=33&t=12341&start=10 that you used the 3ds slider, and was wondering if you could explain how you hooked up the slider to your super pad?
The superpad I have seems to be the same gray one you used which has the following wires going to the superpad analog pots:
VG1
VD1
VC1
VY1
VX1
I assume the VX1 and VY1 are your x and y-axis points, but the VD and VC points i'm unsure of where to connect and its hard to see how you wired yours up in your pics.
I'm using these pots http://www.allelectronics.com/make-a-st ... mer/1.html
the super pad controller and, of course, a 3ds slider.
(I posted this in your worklog thread as well for you N64ortheWin)
I saw from your worklog from viewtopic.php?f=33&t=12341&start=10 that you used the 3ds slider, and was wondering if you could explain how you hooked up the slider to your super pad?
The superpad I have seems to be the same gray one you used which has the following wires going to the superpad analog pots:
VG1
VD1
VC1
VY1
VX1
I assume the VX1 and VY1 are your x and y-axis points, but the VD and VC points i'm unsure of where to connect and its hard to see how you wired yours up in your pics.
I'm using these pots http://www.allelectronics.com/make-a-st ... mer/1.html
the super pad controller and, of course, a 3ds slider.
