Recent content by Unpleasant Monk

Nope, and it is a soft speaker, it is not in a plastic case.

It does, I cut some of the plastic away inside and I have already closed it up, and it fits.

I don't think so, it might be though. However, the LED is good cause I tested it with a battery, and it turned on.

Ok, I took the original red power LED out and test a green one, which worked. So after I removed the solder so I could stick it on and re-solder it now the light will not turn on. But it is powering up because you can hear the volume. Any help would be appreciated.

Here are some pics of it, and thanks for the help. Comparison, and yes it fits in the case. Sry they are so big

Uh, if you had the original speaker hooked up, you might be able to tell the difference. However it seems to be a little louder and now when you have the Gameboy opened and on, the speaker does not rattle. Also um, what size is the power LED in the Gameboy, cause I was thinking about changing...

OK, thanks for the advice everyone, I picked up a 15 watt soldering iron, a vacuum, and some solder. I took out the original speaker and replaced it with my broken laptop's speaker.

Never mind, I decided for a first project it was kind of big, so I added two speakers into it, but then the wire broke so I got to wait till I get a sodding gun. But thanks anyways. Also any suggestions where to put the speakers? I'll get a pic soon.

Hey, I just started modding so I was going to start with a GBC. But is it possible to separate the buttons from the top part? And if so how do you do it? Thanks