Recent content by trevor403

Why not learn how to solder like all the rest of the people who make portables?

I'm pretty sure @megalomaniac uses them as his source too so they should be reliable. I bought a few XenoGC's from them once and they came on time. You should be fine.

Hopefully you're talking about http://www.eurasia.nu/ as your source.

Awesome work! Keep it up! Where were you able to find a pcb to fit the pitch of the pins on the custom regulator?

Remember on your diagram to pump the 5v into the soundfix soldering point for sound safety, or did you not let the mobo have 5v on purpose to keep it away from the old controller vias?

I have been experimenting with the source code from Gecko OS and I may be able to write a clone of TinyLoader that does the same thing for GC games. In other words, it will work with the WiiKey. But testing the bnr should tell if the wii loading or gc loading method should be used.

If you need a really nice set of gamecube ports with pins cleanly exposed i'd suggest using the gamecube controller ports off of a Wii. You can find a really nice cheap broken Wii for anything south of $10. They have raised port endings where as the gamecubes controller ports are thinner lower...

Well the bitstream (bytecode) of an FPGA is protected by AES The firmware for the FPGA is readily available in a hex format. The process Mega would have to go through would be very similar to the one the people at WASP went through. And as we know the WASP is a lot smaller than the WiiKey, if...

Okay so we all know the WASP cable length has limits, but the cable that comes for the wii dvd drive is actually a lot longer than the one that comes with modchips, as they are meant to rest on the board of bottom of dvd drive. So I have this concept for attaching the WASP to the GC that is...

Re: Wii bit smaller: Revisions, Die shrinks, Layers, and mor I have two boards to spare, I wont be cutting them up, anyone who does want to do the work PM me. I'm getting rid of these boards because I wanna get some boards with clean clean NANDs. One board I have already uncovered as a...

Hhehe i will never stop with my huge pictures! Thanks again btw

Awesome, so I didn't short my board! just need to switch the video pin... Thanks Ashen

I'm sure you're all familiar with this board, it goes in the common 3.5" backup cam. It's this one, http://www.ebay.com/itm/like/291268276579. Would anyone happen to know the pinout of the video and power solder points in the red box? The plugs fell out before I could mark down the pins and...

He's right it's at the top of the market. But remember that if you are using a new heatsink, especially one that does not match up to your case or any screw on the motherboard, it's better to use thermal adhesive. The thermal adhesive transfers heat just like thermal past but it also holds the...

Those sdcard slots are so funny, I never thought I would see the Wasp case used like that hahah good job man nice resourcefulness and a great portable.