Recent content by SuperMarioGio

Your very welcome and thanks for the compliment :)

Oh ok sorry about that. I used bondo auto body filler which I bought at homedepot for 11$ this http://www.homedepot.com/p/3M-Bondo-32- ... /202077782 The only glue I used was hot glue to hold the pieces of the gamecube controller to the case on the inside and I used bondo on the outside to...

Thanks, I used a Wii U Protective Hard Plastic case off of ebay I got for 5$ like this one. http://www.ebay.com/itm/Clear-Crystal-F ... 5419fea83d

Yes that is true sanding too less shorts the board because the layers will touch each other. I actually experimented that I only had to cut and sand the grounding strips of the board with the dremel and the bottom grounding strip in order to fit the board in the Wii U protective case. So its all...

Ok thanks for your help. Turns out I may not be able to put this in a Wii-U shell. I will experiment how far to cut the Wii motherboard.

I was influenced by gman's 2nd gamecube portable (Gamecube-U version 2) so I decided to make it similar because I liked his design in other words my portable was influenced by gman's gamecube u version 2 (however mine doesn't look as good as his, mine uses a different speaker grill design than...

In regards to making a Playstation 2 Portable. Do I have to use a PS2 slim SCPH-79XXX motherboard? Because I was wondering if I can use a PS2 slim scph-70012 to make the PS2 slim portable if its possible instead of a ps2 scph-79001 and load Swap magic to install Free Mcboot on my PS2 memory...

Ok Thanks for answering my question. you can get them on ebay now for $19.00. They have loads of them. here : http://www.ebay.com/itm/Original-Ninten ... 1c5099bca3

Not sure if this question falls under here. I am currently making a Wii Portable using an official Wii U Shell like this (Picture is not mine all credit goes to original owner). And I was wondering if it is possible to put a untrimmed Wii Board in a Wii-U Controller shell or in a hard...