Recent content by morgrif

loving the look of your GBCube so far :O do you mind linking me the Schematics of your regulators? I recently got back into working on my portable GC and I fried the 3rd orginal reg board (they fry so easilly...). Tought I'd finally get into making a true set of regs. Let me know if you can

sry for that ashen, could you give me an answer to the problem tough? I'd apreciate. thanks in advance

It's ok, as i told you that board is allready fried anyway. Here some hazy (flaxty cellphone) pic: Both are dol-cpu-01, in the left one (the one I mentioned before there's a 14legs amp' and a single bigger Cap. oposed to the 1R + 2Caps + 8 legs amp ar 2946. Also, I got a small problem doing...

Mine is pal too. maybe you were lucky enough to have a rev.a or b that is similar to those that ashen had in hands. I can't say if mine is rev.a or b tough but I promess I'll soon post a picture of it. cheers

Was that an answer to my post? if yes, no my board wasn't rev C....

my board was diferent from the one you used in the example so I couldn't find those caps/resistors where you were taking Video From on mine. Was gonna test mind with sound only just to know if it was working tough I think I fried it anyway so, doesn't matter... Think I was to ambitious to start...

Re: GameCube Fusion Rev 3. (Sneak Peak) Thing is... It really looks like it!!! O.o Now I'm really curious too!

you are the true meaning of awesomeness... that thing can't be called anything else than perfect... congratulations

@Sony sry to disapoint you but GND is a voltage level like any other. If you are doing an electronical circuit of any kind and input 5V on youre GND line and 10V on youre +Vcc line it's exactly the same thing as putting 0V and 5V respectivelly on them. GND is usually the designation used to...

@SonyQ He was asking for another spot in the controller board to get GND voltage from... @thread starter Tried Ashen's controller scheme? or is youre controller non-oficial?

Hey there again Ashen. (I also posted this on BenHeck forums btw) I've been working arroun the controller since today afternoon and my idea is to cut the controller arround ABYX part. http://www.youtube.com/watch?v=SkaSO6Gz53I I saw that vid of youres and there's some stuff I'd like to ask...

I hope you get answered on this one as this is actually one of my doubts right now.

First off sry to know that youre cube might have gotten fried up =/ Second, in one vid of youres i noticed you the the wire memcard well. Could you plz take some close up pics of the wireing. I'm doing it using Ashen guide but I'd like to confirm with some look up at a finished one before...