Recent content by horzza

  1. H

    ~ Xbox Adventures ~

    http://store.mp3car.com/Mini_Box_picoPS ... wr-038.htm Considered something like this? I'm not sure if that's the right one for the xbox but there are a few different ones on that site, for different output powers and pin counts. Story was impressive btw. Wish you didn't cut it short. Those...
  2. H

    Official Wiikey Fusion to GC MOD troubleshooting thread!

    I used the same switch and the NC is and C are on opposite sides, so I'd say that that much is wired up correctly. This may also sound silly but perhaps the problem is because of the 36 pin adapter board, maybe not contacting correctly or something? I was concerned before I re-did mine that it...
  3. H

    Official Wiikey Fusion to GC MOD troubleshooting thread!

    http://www.youtube.com/watch?v=a8q-elxC6gU I am this happy. Did a clean sweep, de-soldering the breakout and checking it for continuity - all fine. I think you were right, in that it was a grounding problem, as that makes sense with the me-touching-ground-and-pin-29 thing, and just the strange...
  4. H

    Official Wiikey Fusion to GC MOD troubleshooting thread!

    Switch has been replaced by a momentary NC, and it still refuses to work, just the same. Blue LED comes on once, dimly, after the button is pressed, followed by nothing. Can someone confirm if this could be a problem with the SD card itself or the cable leading to it? If you guys boot your WKF...
  5. H

    Official Wiikey Fusion to GC MOD troubleshooting thread!

    LOL. Thanks anyway. I'll swap the switch when I get time. I'm thinking it's something to do with having pin 29 float, and not tied to a voltage. I'll try pulling it low through a resistor, then using a normally open switch to pull it to 1.9v. this failing, would 3.3v on pin 29 break anything?
  6. H

    Anyone have any experience with making a clock?

    You could always start with one of those black-and-white cat clocks with the eyes that move opposite to the tail, which is the pendulum. Another option is to start with a a module you might find at a craft store. In tech in high school we had to make a clock, and were given the choice but I...
  7. H

    Official Wiikey Fusion to GC MOD troubleshooting thread!

    Thanks Ashen, for pointing me here and your help so far ^^ I'm on a PAL DOL-001, and not experiencing any of the lock ups associated with the wrong IPL, and have my region switch set correctly as far as I can tell. I broke-out each of the traces of the FFC to an intermediate PCB, which I have...
Back
Top