Recent content by ABOUT90HAMSTERS

i have one that i made on my own. there is a way that you can make it work as both an x box original controller and a pc controller, if any cares i could post up a guide on how to do it.

in theory with the right resistors could you make any type of resistence analog stick, say a 360 controller with these resistors?

sorry about that, i was just brainstorming.

for a trigger in the back why not take one of the dreamcast controllers and take the back of the controller with the triggers intact and just franken-case it into the shell also making it a cover for the disc drive. it would looker cleaner in my opinion. the controller im talking about is the...

well i thought since you were using a round cell that the case would be rounded...... so i dont know what i was thinking.

http://forums.benheck.com/viewtopic.php?f=43&t=34576 -battery guide and static only kills when it isnt humid! :tophat: ..... and if something is rectangular squares should fit.

for the first one in the trimming guide there are pinouts of a chip you can find on the motherboard that outputs audio and video just solder them to the corresponding points on the port. but if you dont trim and the port is still on there you can either just solder to the same pin video comes...

since your portable is going to be square why not use batteries like in hailrazers guide? or does your design constrict the use of squares?

Re: Gamecube VITA WORKLOG!!!! what about the big chips above the cpu? dont they need to be cooled by a heatsink too.....

couldnt in theory you just take the twelve volt line from your regulator and wire it to the screen or would that cause too much of an amp draw?

Re: Fusion Micro ~ Worklog just to give an idea, zenloc is using a 3ds analog stick with a psp nub on top... maybe you could use that analog with the stock nub and it would look the same but mechanically work better. im reffering to the analog and not the trigger.

take off the tact switch and if it still makes the repetitive pressing i would get a new controller

Re: GameCubeMini Prototype worklog hhhhmmmm.... I've been wondering about those 3ds analog sticks, how are you going to wire them up and how did you make the nubs on top?

does anyone know the ohms? on that link they said 18d ohms but i think that is some other number....

Re: Use Usb External Harddrive That Is NOT Externally Powere i think the lines on a usb plug are datta grounding and a 5 volt line.... test it on your pc with a multimeter. i think what i said was right! just deliver the right voltage to it and it should work. it might need ac current though.....