Why doesn't this jumper relocation work?

βeta · **Posted:** Sat Mar 10, 2012 11:49 am

SS has wired it like 8 times, and we are getting no results. The board has been confirmed to work after every attempt. Any ideas?

Click the image for a bigger one.

βeta · **Posted:** Sat Mar 10, 2012 1:56 pm

Another attempt:

Click to embiggen it.

βeta · **Posted:** Sat Mar 10, 2012 5:16 pm

*PLAQUE* it, we got it working, no thanks to anyone.

brunoip · **Posted:** Sat Mar 10, 2012 6:57 pm

Still not as small as a tic-tac box :rofl:

Bibin · **Joined:** Tue Jun 02, 2009 5:43 pm **Posts:** 1469

is this a resolder or a bend-n-mount?

βeta · **Posted:** Sat Mar 10, 2012 8:55 pm

Resolder.

clarky · **Posted:** Fri Mar 23, 2012 2:47 am

If you're careful then you don't need to resolder.

βeta · **Posted:** Fri Mar 23, 2012 8:07 am

It's resoldered to the very top of where the port goes, we needed that extra trimming. Folding it up wouldn't have been enough.

Ashen · **Posted:** Fri Mar 30, 2012 12:36 am

This is the only reason I can see why this didn't work:

Pin 23 should have connected to C5 on the jumper pack.

That may not have been it, but I just pinned this all out for myself with a multimeter to see where flax goes both on the board and on the jumper pack. I also looked at a flax ton of diagrams and other people's work and its the only thing I can see that you guys don't have connected in that pic.

I'm going to give this a go here real soon. I already got the ramswap done tonight.

I know this is to little to late as far as this thread goes. But may be helpful in the future.

public-pervert · **Posted:** Fri Mar 30, 2012 5:29 am

Quote:

*PLAQUE* it, we got it working, no thanks to anyone.

Thanks to Marshallh for the idea. Good work anyway.

Why doesn't this jumper relocation work?

Who is online