The Controller

18masterkyle · **Joined:** Mon Jun 22, 2009 12:02 pm **Posts:** 48

(self explanatory ). Could some people post their pictures of their modified controller. This is very confusing for me

XCVG · **Posted:** Mon Jul 20, 2009 8:37 am

Basically, you wire to where the buttons were. You cut apart the controller leaving the resistors and the chip. It's a little hard on an original NES controller because of the way the resistors are arranged. You may have to replace some of them. Then you rewire your other buttons, tact switches, whatever, to where the buttons were. I used some random NES joystick; all the resistors are in one place on it. I used a junk N64 controller for the buttons.

goatboy · **Joined:** Mon Jul 20, 2009 11:17 am **Posts:** 5

When going about adding the controller elements how do you all go about doing it? Do you make a now board? or just adjust the one inside the contr? Any help with items i'll need and examples would be great help.

eurddrue · **Posted:** Mon Jul 20, 2009 11:45 am

perhaps this picture will explain it?

goatboy · **Joined:** Mon Jul 20, 2009 11:17 am **Posts:** 5

I understand, that helps. I have ben's book and didn't want to have to make a whole new contr mother board if i didn't have to. thanks guys.

The Controller

Who is online