Hey, I just finished adding the Wiikey Fusion to my GC. I turned it on and everything worked fine. So I run the update. I get to the final screen: "Done! Press A to reboot." I do so. And after the GC rebooted it couldn't read the Wiikey anymore. When I go to Game Play it keeps flashing between the messages: "Please insert a NINTENDO GAMECUBE DISC" and "Reading Disc...". And the blue LED isn't turning on. Any ideas?

Are you using a adapter board?

No, I used this method:http://www.gc-forever.com/forums/viewtopic.php?f=26&t=759

Make sure its plugged in right, and also test to see if the Wiikey works on a Wii.

I reconnected the FCCs and looked over all connections. Everything looks fine, but it's still not working. I'm going to grab my multimeter in a bit and recheck every individual pin connection. And unfortunately I don't have a Wii to test it on.

Its working fine. You need to hit the "eject" button to load the linux bootloader.

_________________

When I hit the eject button the GC freezes. I even added the 1.9v line and it made no difference.

What revision is your motherboard? DOL-CPU-xx?? Printed by the cpu chip. Sounds like an ipl v1.0 board

_________________

DOL-CPU-11

I tried turning on the GC while pressing the eject switch and it worked. I rebooted to try it again and it got stuck on "Reading Disc..." I tried it again and got "An error has occurred. Turn the Power Off and check the Nintendo GameCube Instruction Booklet for further instructions."
I kept trying and eventually got it to start again. Is this how it acts on an IPL v1.0?

Yes, bad luck man. Looks like an IPL v1.0 board. If you hold in the eject switch at boot and time the release of it right it will load the linux loader. However most games will hang when a game is selected and the GC is rebooted. A few will play though. :/

Time to get a new board.

_________________