Pics as promised
I was origally going to have two batteries inside, but they took up too much space. The next few pictures are of the awesome battery slots I built, then had to remove
N64 grounding strips
Glued in place (You can also see the peices from a N64 vent that I glued down for the batteries to slide onto.)
They fit so well
7805 regulator screwed onto a N64 heatblock. (I also cut off a corner of the heatblock so it'd fit next to the speaker)
The front with all the buttons installed. I made my own 4 way tact cover from a wii analog cap
flax switch hole. Its too big because the only way my file would fit to make the hole longer was to make the hole wider. :/
Toroid and a diode, most of the wires are there too. The audio amp is under the tape up at the top.
4 way tact pinout written on the inside of my case so I couldn't lose it
My volume knob ala ShockSlayer
Power jack from an ebay screen
Power jack installed.
Remember that I'm building this away from most of my tools. All of the holes that I've made in this case I used my dremel and grinding bits, so they look awful. Funtional, but awful.
My screen still hasn't come. I'm about to go and curb stomp china.