Nintendo64/Gameboy advance

designer noob · **Posted:** Fri Jul 03, 2009 11:49 am

The red and black wire are postitive and negative on the Ti card correct. THe ones that are off on thier own? Also, I don't have to put it through a regulator just connect to the battery?

To hook the GBA just hook a wire to the positive and negative on the circuit board right?

sorry, but I rather be 100% sure can't mess this one up.

designer noob · **Posted:** Fri Jul 03, 2009 12:38 pm

In, this picture there are two wires red and black are they power?

Also, when you open up the GBA where you use to put the batteries in is where the wires for the power go right?

designer noob · **Posted:** Fri Jul 03, 2009 12:48 pm

oh ok, then I can just hook up my batteries directly(without going through the pth0800) to those wires and the converter will regulate the current to the GBA and it self.

designer noob · **Posted:** Fri Jul 03, 2009 1:33 pm

kk, ty

designer noob · **Posted:** Sat Jul 04, 2009 10:36 am

I will be hooking everything up for real in a couple of days and I was wondering sometimes the wires have to break into two or three wires. If you just put solder on the connection they won't hold that well. You also can't put shrinking tube on it. So, I was wondering what do you use that secures the three or four way connect wire? I was thinking you could cut a little more of the wire off and twist them together, but I don't think that would work. It still would be to large.

XCVG · **Posted:** Sat Jul 04, 2009 11:55 am

You take them, twist them together, solder them, and then put heatshrink over the thing.

designer noob · **Posted:** Sat Jul 04, 2009 1:19 pm

kk, thanks.

designer noob · **Posted:** Sun Jul 05, 2009 1:11 am

Sorry, waiting for heat shrinks, and N64. I wan't to do everything perfectly this time. I will be posting tons of updates in the next couple of days when I get those items. My portable should be done by the end of the month or maybe earlier if everything goes right.

designer noob · **Posted:** Sun Jul 05, 2009 11:51 am

Today, I am going to get a rotational cutting saw and I was wondering are any alright to use?
I know it should be diamond covered.
Should there be a certain amount of speed or size of the saw or will I need more than just one size?

eurddrue · **Posted:** Sun Jul 05, 2009 12:15 pm

Why don't you get a dremel tool? Those can be rotary saws, drills, nearly anything! I have one and I totally recommend it.

Nintendo64/Gameboy advance

Who is online