Search results

So I tried...resistance on one diode is one is lower on one than the other...also when connected together is 14...but still no go....sanded a bunch more as well. Should I be removing the component from the excess I left?

I believe I tried t, but I'll do it again to rule it out and update.

There is actually still continuity between bet the points in ashens guide....those diode looking things. I don't think a cable between both is required. Correct me if I'm wrong

So it's 30 ohms right on. I tried sanding this thing down a few times, but still nothing. I did notice that both CPU and GPU and heating up now though. Any other suggestions?

I can try sanding again in the morning. I used a rotating bit to sand. This is what I always used with my n65 cuts. What grit would you recommend? Also, is the crystal polarized does it have to be wired a certain way? What's the best way to use my fluke to find a short? For some reason there is...

So this ended up being amperage...i fixed it by buying a 2.5A PSU. Everything worked fine before my OMGWTF cut. I have a few boards to mess around with, so i wanted to try this one out first...I think the next one i might do the cut before this one. Anyway, I did the the and am not getting any...

like other chargers it's rated at 8.4v though...i have a 8.4v 2.5a charger on it's way :) what kind of amperage does the gc require to run?

I currently don't have batteries connected. It's going straight from the charger.

Hello, Just looking to get some help with GC portable power wiring. I know these boards work because they come from badassconsoles. I've wired it using shockslayers TI regulator wiring diagram. 1.9v 3.3v 5v I've also wired it as a trimmed board right to the components even though it's not...

Re: Portable Gamecube Build- STILL FOR SALE What's the case made from? Vacuum form?

Pmed