Recent content by nass95100

Yes it is

Yes I did, and I tried with three differents SD cards

I ordered a new megadrive becauseI fried the other one with my heat gun lol. So, I got the new one did the solder with wires this time, to be sure there is no soldering problem but when I start my GC with SD on it, I need to click the P29 switch to get the blue light and then, nothing. I get to...

Updated the first post. I'll update on the first post from now, it'll be easier to read the progress of my project.

Ok thanks a lot :mrgreen: And it seems like this diagram doesn't use the same resistors as zenloc's diagram (1kohm instead of 903 ohm, etc..) does it have a real impact or the amp draw is just a bit higher?

It depends of what? And which datasheet?

Hi everyone, I finally figured out how the regs were working and now I'm going to make them, I laready have the capcitors, the resistors and the TI regs.I'm actually looking at Zenloc's diagrams and I can see that he uses two caps for reg. And I know that for the 5V line the output cap is...

Region____________________________________Switch _______________________________________ 1 2 3 4 UK/Europe/Australia/New Zealand - PAL On On On On USA/Canada - NTSC Off On On On Japan - NTSC-J...

That's why

I tested each solder joint with each filter and they all seems to work... I'm quite confused, maybe I'm doing it wrong...

Well, I sent a mail to megalomaniac and he told me that all his wasp are preflashed with swiss autoboot. And to I checked my solders with a continuity tester, but I don't if I did right : I put my multimeter on continuity tester (it makes sound when the two sides are connected) and then I put...

Hi, First of all I want to say that i'm totally noob concerning the WASP/WKF and i'm sorry if my questions are quite stupid. So, I ordered a megadrive and a wasp to megalomaniac's website and I received them and installed them with the pin 29 connected to a switch. In all the videos I have seen...

Ok I have found another relocation point for the composite signal. I will provide a photo when I will receive my new mobo (tomorrow I guess) because the other one is quite messy and we can't really see the pad.

Here is the other side of the board:

Thanks for answering man, but there's no other way to get composite video? Because it requires some tiny solde rs and i'm about doing a short circuit and fry my board