Recent content by LazySpencer

IT WORKS. I'll be posting a video of this first prototype once I get the case around the screen shaven down a little more. Also, for anyone who reads this, I connect REVC to the GND (ground) which is located right above all of the pins (you can Google it to find it or something, otherwise stay...

I've been twisting and turning the trimpot through the back of the GBA and literally this is best picture I can get without there being a TON of lines across the screen. Any ideas? My soldering joint seams pretty solid and connected well, and I feel like if I bumped the wire I'd get...

Finally got the LCD installed into my GBA and got images to appear. Now however my issue is that the image is faded/washed out. I've messed with the potentiomete/trimpot thing but I don't know if I should be turning it more than 1 full turn in either direction. I don't want to forget the OG...

Couldn't figure out how to delete my original forum post after finding out what I did wrong (maybe being on here with my phone us the reason, not sure). Anyways, what my issue is now, is that my screen is backlit, but the image isn't completely saturated like it should be, it's faded/washed...

Hi, You may have seen my other post about switching GBA LCD's with the SP. I have 2 of everything and so I got impatient with the first GBA board and I believe it is fried so I moved onto the next board I had. If you look below, you should see that it appears everything is connected...

Hey everyone, Assuming if you're reading this you are decently familiar with the process of swapping out LCD's from the original GBA screen to a 2nd generation GBA SP screen (aka, the AGS-101 screen). I ordered 2 40-pin ribbon adapters because that's what my GBA(s) require. I've got some ideas...