MMumble
Member
So I've seen a lot of stuff on soldering buttons and even triggers with 2 tact switches, but I'm wondering how exactly you would solder the Left Analog and C analog sticks.
According to Kasar's Guide, these are the main locations to the outputs:
http://www.slagcoin.com/joystick/pcb_diagrams/gc_diagram1.jpg
Then there's this pic I found that show's on the locations on the chip:
http://i628.photobucket.com/albums/uu4/Ashen12345/GC Controller Trimming Guides/1.png
One thing I noticed is that the chip has the X axis for input and Y axis for the analogs.
But from what I see on Kasar's guide just shows one pin for both inputs?
I'm confused. Pls halp.
According to Kasar's Guide, these are the main locations to the outputs:
http://www.slagcoin.com/joystick/pcb_diagrams/gc_diagram1.jpg
Then there's this pic I found that show's on the locations on the chip:
http://i628.photobucket.com/albums/uu4/Ashen12345/GC Controller Trimming Guides/1.png
One thing I noticed is that the chip has the X axis for input and Y axis for the analogs.
But from what I see on Kasar's guide just shows one pin for both inputs?
I'm confused. Pls halp.
