Recent content by robm

bizzurp

BURP

burp

WiiuuWiiuuWiiuu

Beautiful console.

Ok, thanks for the feedback, guys. Ultimately it's going to end up being whatever I can afford first and what deal I can run across, right now demand is high while supply is low, I could have picked up a DK1 for dirt cheap a while back but right now I can't find anything less than $800 in my...

Hey all. I've finally broken out of my 750 ti and upgraded to a 780 ti, which is supposed to be roughly approximate to a 970 in performance. Anyone out there having any success running a VR headset with less than recommended specs? I'm trying to slowly climb up to getting one VR headset or...

Very, very clean. I love it.

As I quit being a Zelda fan after the NES games, if someone showed this to me and said "Hey this is SNES Zelda," I would say... ok. Very nice, is your goal to be entirely a Zelda clone? Or is this kind of like your own deal that just happens to look a lot like Zelda?

Picked up a Thermaltake Chasar MK-1 off of Craigslist for $10... I'm beyond stoked, if sad to see my Antec AMG go. http://www.newegg.com/Product/Product.aspx?Item=N82E16811133191

love... baby don't hurt me

Pics of the disc, edge-on, top, and bottom? Only way a disc is going to damage a PS2 is if it's got a ton of crud on it or is warped somehow. As for the invalid input, where did you buy this disc? If you bought it online, did you make sure you didn't buy a PAL disc for your NTSC console?

I like this a lot, good job.

I am actually getting things moving along quite nicely, finally! I think, in the end, the problem was a dusty bed surface! LOL Thanks to Mario for helping me out on that, I'd been wiping it off with a paper towel, but still wasn't getting adhestion; he suggested an alcohol wipe, took care of...

Unfortunately I haven't had a ton of time over the past couple weeks to fight with it, but I'm running a Printrbot Plus V1 with what I assume would be the filament they ship with new units, though don't quote me on that. I think I'm to the point where I'll have to try drilling out the nozzle as...