Nope, the megadrive gets 3.3V from your busted line... Do you get continuity between 3.3V and gnd?
Do you get the correct voltages at the various points shown on the trimming guide? And make sure the edges you have cut are sanded A LOT.
Check voltage points all across the board. Pictures would be good too.
Check continuity between the wasp pins and pin on the gc mobo. Can you give us a pic of your soldering?
Do you have an sd card inserted?
1- they are usually rated for 5-15 amps so it shouldn't be an issue. I run my gcp off my car's 12V with no problems. 2- As simple as soldering...
Does it have an hdmi or vga output? It could be used as a linux entertainment system (kodi/netflix/emulators)
That is some very nice work! Looks comfortable to hold.
Wow this really turned out great! Beautiful design. How are you going to protect the screen during transport?
You could solder to the traces connected to the missing solder pads. Expose the copper under the traces by scratching off the masking with an...
Holly flax! That is really amazing work... It all looks so professionnal. I've never seen anyone do such adavanced things for a gamecube portable....
You just measured a resistance value :P . You have to turn the knob to the DC voltage reader (upper left area). Start at 600, then go down one...
People on this forum seem to like the pam8403. Personally I used adafruit's class D audio amplifier which give great sound. You could also tear...
Yeah official controllers are pretty expensive, the smash bros controllers are pretty much identical to the old ones and not so expensive on...
That seems perfectly feasible! No it's not. Just make sure that whatever unused pots (triggers, analog sticks) are replaced with resistors. It's...
Separate names with a comma.