How much just for the motherboard?
1 word awesome portable :cool:
Im looking to see if someone could make me 2 shoulder buttons for the wii u protective case that will fit nicely without it falling...
Wii OMGWTF CUT can't wait to see :awesome:
Are you planning to trim the board any? :roll:
OK I wired up the regulator to 2 different Gc 1 is a Rev C model and the other 1 is the standard one the Rev c powered one but the other 1 which...
Alright thanks Gman :mrgreen:
they're 100uf 25v each
Thanks I was making sure before I processed wiring up the caps and wires I didn't put uf caps on yet I wanted to make sure the resistors were on...
Can someone check and see if this is done right [img]
Try using a diamond cut wheel
Would that stick to the plastic?
How do I go about molding one of my cases is there another method besides using liquid plastic?
Separate names with a comma.